Overview
The DuoDrive (Model 9870) allows HDTV signals to be distributed throughout the home from a single source.
Component video (YPbPr), analog stereo audio, and digital audio (coaxial) signals are included in each two-cable
Cat 5 pathway. By connecting IR remote control systems to the DuoDrive system, users can easily control the source
equipment from other rooms in the house. IR receiver and emitter products are not included with the DuoDrive.
System Design
The DuoDrive is comprised of one Model 9871 RCA-to-Category 5 Driver and two Model 9878 wallplate/receivers.
(Two other Cat 5 receiver styles are also available, Models 9879 and 9880.) These products enable distribution of
audio, video and IR control signals on Cat 5 cable runs of up to 1,000 feet. The buffered Cat 5 bus outputs on each
9871 drive one or two wallplate/receivers. To expand output capacity of the system, connect together an unlimited
number of 9871 Drivers using Kit 46, included with each Driver. High quality RCA patch cables can also be used
for expansion.
9878 Wallplate
RCA INPUT
Cat 5,
Cat 5e,
or Cat 6
Cable
9871Driver9871Driver 9871Driver
ABAB
offers a wallplate format to fit a
standard two-gang electrical box,
and includes an RF pass through
jack.
The 9879 is a single gang Decora
style wallplate with two different
IR connection options. The 9880
is an enclosed version ideal for
locations where a wallplate style
receiver is not practical. DC power
AV Source Component
ANALOG AUDIO
DIGITAL AUDIO
COMPONENT VIDEO
Connect all bus jacks
including IR (Kit 46 shown)
AB
9878 Wallplate
Note: This
configuration of
three 9871 Drivers
could support six
wallplates.
One power supply required
for each 9871 Driver
(18-volt DC, center-positive
Part# 571-014)
Model 9879
Model 9880
Model 9878
AV Equipment
DuoDrive™ Residential Category 5 HDTV Distribution System
Cat 5 Wallplate/Receivers
All three wallplate/receiver styles deliver component video, digital and analog audio, and IR signals. The 9878
CAUTION!
The bus output jacks should
not be connected to a TV or
receiver unless the line is
properly terminated. Call
Audio Authority for details.
for each wallplate is supplied through the Cat 5 cable from the 9871’s power supply.
Rough-In
Wallplate/receivers are normally placed on the wall behind the television sets or entertainment centers remoted off
the main home entertainment system. Set a plaster ring at each wallplate location. Pull two runs of good quality
Category 5, 5e or 6 UTP cable from the head-end location to each wallplate/receiver location. Be careful not to
pinch, kink, or tightly staple the cable. Mark both ends of the cables in each set A and B, or use two different jacket
colors of UTP cable for A and B. It will be helpful to mark the cable length of each run at the wallplate/receiver end
because you will have to adjust the cable length compensation when installing each wallplate/receiver.