Setting Surface Controls
ESEC Hot Element Indicator Message (HE)
After using any of the single, dual or Bridge radiant element positions the cooktop will become very hot. Even after turning the control knob to OFF, the cooktop will remain hot for some time. The ESEC control monitors the temperature of the cooktop and displays the message “HE” (hot element) warning when the cooktop is still too hot to touch (See Fig.1). If the HE message appears in the window, the control can still be turned on again for use.
ESEC Error Indicator Message (Er)
An error message will be displayed (flashing “Er”) at power up (or after a power failure) if ANY of the surface control knobs were left in the ON positions. If a power failure should occur, be sure to set all of the 4 surface control knobs to the OFF position (See Fig. 2). This will reset the surface controls.
Be sure to reset the clock (See page 16). Once the surface controls have been set to the OFF positions and the clock has been set with the correct time of day, the surface controls should return to normal operation. If the surface controls do not function and the “Er” message remains in any display after following these procedures, contact an authorized servicer for assistance.
ESEC Lockout Feature ( - - )
The
The Single Radiant Surface Elements
The cooktop has single radiant surface elements at 2 locations; the right rear (Fig. 5) and left rear (Fig. 6) element positions. The BRIDGE element position can also be used as a single element (See Bridge Element Operating Instructions on pages
To Operate the Single Surface Elements:
1. Place correctly sized cookware on the radiant surface |
|
element. |
|
2. Push in and turn the surface control knob in either direction |
|
to the desired setting using the ESEC digital display |
|
window for the desired setting (Fig. 4). Turn (do not push) |
|
the knob to adjust the setting if desired. Start most |
|
cooking operations on a higher setting and then turn to a |
|
lower setting to finish cooking. Each surface element |
|
provides a constant amount of heat at each setting. A |
|
glowing red surface heating area extending beyond the |
|
bottom edge of the cookware indicates the cookware is too |
|
small for the surface heating area. |
|
3. When cooking has completed, turn the surface control |
|
knob to OFF before removing the cookware. Note: The HE |
|
message will appear after turning the control knob to OFF |
|
if the cooktop is still hot and will remain on until the heating | Figure 4 |
surface area has cooled sufficiently. |
Note: See page 8, Figure 5 for recommended control settings.
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
9
Figure 1
Figure 2
Figure 3
Figure 5
Right Rear Element
Figure 6
Left Rear Element
