Frigidaire ES40, 316257124 Removing and Replacing the Warming Drawer some models, Care & Cleaning

Care & Cleaning

Removing and Replacing the Warming Drawer (some models)

To Remove Warming Drawer:

1. Turn power off before removing the Warming Drawer.

2. Open the drawer to the fully opened position.

3. On the right glide you will find a shield attached with a hex-head screw

(See Figure 1). Using a 1/4” socket and ratchet remove the shield.

4.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever.

5.Pull the drawer away from the range.

To Replace Warming Drawer:

	1.				Replace shield on the right glide of the drawer body.
2.					Pull the bearing glides to the front of the chassis glide (See Figure 2).
			3.		Align the glide on each side of the drawer with the glide slots on the range.
				4.	Push the drawer into the range until levers “click” (approximately 2”). Pull
					the drawer open again to seat bearing glides into position. If you do not
					hear the levers “click” or the bearing glides do not feel seated remove
					the drawer and repeat steps 2-4.This will minimize possible damage to
		Figure 1			the bearing glides. Using a 1/4” socket and ratchet replace the shield.

NOTE: The Warming Drawer will NOT operate while in the “Self-Clean” and “Oven

Lockout” modes.

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the Warming Drawer.

Figure 2

Operating and Replacing the Oven Light

	Be sure the range is	To operate the Oven Light:
unplugged and all parts are COOL before		The interior oven light will automatically turn on when the oven door is
replacing the oven light. Wear a leather-		opened. Press	to turn the light ON and OFF when the oven door is
faced glove for protection against possible
broken glass.		closed. The oven light is located at the rear wall of the oven interior and is
		covered with a glass shield held by a wire holder (See Fig. 3). The oven light
		glass shield must be in place whenever the oven is in use.

To Replace the Oven Light:

1. Turn electrical power off at the main source and unplug the range.

2. Press Wire Holder to one side to release the glass shield.

3. Replace the old bulb with a new 40 watt appliance bulb.

4. Replace Glass Shield over bulb and snap Wire Holder into place.

5. Turn power back on again at the main source (or plug in the range).

6. The clock will then need to be reset. To reset, see Setting the Clock in this Use & Care Manual.

Figure 3

Care & Cleaning of Stainless Steel (Stainless Steel models only)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Please refer to the table provided at the beginning of the Care & Cleaning section in this Use & Care Manual.

34