Datalogic Scanning 9500, 9504 manual Error Codes

Error Codes

Error Codes

If an error is detected, the scanner will sound a long low tone (for one sec- ond) and alternately flash its LEDs, indicating a failure. Following the long low tone, an error code will appear on the 7-segment display (refer to Figure 4-1). Pressing the Volume/Tone Push button will cause the scanner to sound a series of beeps corresponding to that error code. The table on the following page describes what these codes mean and what action should be taken for each.

When troubleshooting, always remember to check all cable connections first before proceeding with other problem isolation steps.

NOTE

Product Reference Guide 4-3