Programming Overview

 

It is recommended that programming sessions be limited to one feature at a

 

time. Should you make a mistake in the programming sequence, it can be

 

difficult to discover where an error has been made if several features are pro-

NOTE

grammed at once. Additionally, it can be confusing to determine which fea-

tures may or may not have been successfully set following such a session.

3.Scan the SWITCH bar code to save any new settings and exit Pro- gramming Mode. The scanner will sound a beep and reset upon exiting Programming Mode, and the green LED will return to its usual state (on steady or off).

The scanner will exit Programming Mode under the following con- ditions:

the programming sequence has been completed or the SWITCH bar code is scanned

five minutes have passed without scanning activity. Any data programmed during the current session will be ignored1, and the scanner will reset and revert to its condition previous to initiating the exited session.

power is disconnected. Disconnecting power during Pro- gramming Mode, before scanning the SWITCH bar code, will cause all new settings to be ignored. On power-up, the scanner will return to previous settings.

4.Maintain a good record of all changes made to ensure that you know if the original factory settings have been changed.

1.Exception: If an interface bar code had been read while in Programming Mode, the scanner will operate on the default settings for the new interface.

Product Reference Guide

6-7

Page 123
Image 123
Datalogic Scanning 9500, 9504 manual Programming Overview