RS-232 NAK Character
This feature specifies which ASCII character will be used as a NAK char- acter.
NOTE
DO NOT set this feature to use previously defined characters such as XON, XOFF or host commands as this will conflict with normal operation of these characters.
To specify the
1.Scan the SWITCH bar code.
2.Scan the bar code, SET
3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the hex designation for the desired character. A table contain- ing the ASCII Character Set and their corresponding Hex Values is available in the inside back cover of this manual. ASCII parameters must be input by scanning a pair of hexadecimal digits for the desired character. For example, if ASCII “A” were the desired NAK character, you would scan the digits “4”, then “1” (the ASCII corre- sponding hex value).
4.The scanner will automatically exit Programming Mode when the appropriate amount of digits/characters have been scanned.
SET
| Magellan® 9500 |
