Datalogic Scanning 9504, 9500 manual Operational Verification

Figure 2-10. Remove Protective Vinyl

Protective vinyl MUST be removed from the platter before use.

•Proceed to the Operational Verification instructions below.

Operational Verification

Follow these steps to ensure that your unit has arrived undamaged and is fully functional before installing it in the counter and connecting it to your POS system.

1.Connect the scanner and the EAS antenna to the EAS Controller Box (see Figure 2-20and Figure 2-21) and power-on the controller box.

2.If the unit is a scanner/scale, connect the Remote Scale Display to the proper connector on the unit’s connector panel (refer to Figure 2-14). Note that if the Remote Scale Display is not con- nected, a scanner power-up Selftest will sound a long, low beep, and the number “8” will appear on the 7-segment display indicating a remote display error. Power-down, connect a known-good Remote Display to the appropriate port, and restart to correct this problem. Alternatively, you can disable the Remote Display using program- ming bar codes (see Chapter 6, Programming for more informa- tion).

3.Connect the power cable at the scanner, then at the AC outlet.

2-20 Magellan® 9500