Datalogic Scanning 9500, 9504 manual To set the EAS Beep Duration Scan the Switch bar code

EAS Features

EAS Beep Duration

Sets the duration of the EAS successful deactivation beep, specified in 10ms increments. The beep only occurs if EAS mode is not disabled.

To set the EAS Beep Duration:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET EAS BEEP DURATION below. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the desired EAS Beep Duration. The selectable range is 0- 255, which is the timeout in 10-millisecond increments. Pad all sin- gle and double digit numbers with leading zeroes to yield a three- digit entry (000-255).

Examples:

000 = EAS beep disabled

001 = 10ms

005 = 50ms

040 = 400ms

250 = 2,500ms (2.5 seconds)

4.Complete the programming sequence by scanning the SWITCH bar code.

SET EAS BEEP DURATION

Product Reference Guide 6-51