RS-232 Host Echo Quiet Interval
This setting specifies the time interval of RS-232 channel inactivity which must transpire before the scanner will break the host echo loop to transmit the bar code data that has just been scanned to the host.
•0 - 100 = Time in 10-millisecond increments. To set the Host Echo Quiet Interval:
1.Scan the SWITCH bar code.
2.Scan the bar code below, SET RS-232 HOST ECHO QUIET INTER- VAL. You’ll need to cover any unused bar codes on this and the fac- ing page to ensure that the scanner reads only the bar code you intend to scan.
3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the desired timeout. The selectable range is 0-100, which is the timeout in 10-millisecond increments. Pad all single and double digit numbers with leading zeroes to yield a three-digit entry (000- 100).
Examples: 001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4.The scanner will automatically exit Programming Mode when the appropriate amount of digits have been scanned.
SET RS-232 HOST ECHO QUIET INTERVAL
