General Scanner and Scale Features
Good Read When to Indicate
This feature specifies when the scanner will provide indication (beep and/ or flash its green LED) upon successfully reading a bar code.
•Good Read = Indicate after decode
•Good Read = Indicate after transmit
•Good Read = Indicate after CTS goes inactive, then active
The “Indicate after CTS goes inactive...” mode applies to
232 WN interfaces only. If set to this mode in other interfaces, “Indicate after decode” mode will be implemented.
NOTE
To set the Good Read When to Indicate feature:
1.Scan the SWITCH bar code.
2.Scan the desired mode bar code from this page. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.
3.Complete the programming sequence by scanning the SWITCH bar code.
GOOD READ = INDICATE AFTER DECODE
Product Reference Guide |
