Standard 2 of 5 Enable

Standard 2 of 5 Maximum Label Length

 

This feature specifies the maximum allowable length of a Standard 2 of 5

 

label.

 

Length in this case includes check and data characters, but does

 

not include start or stop characters. This feature applies when

 

Standard 2 of 5 Length Control is set to variable-length decoding.

NOTE

Maximum label length should be greater than or equal to minimum

label length.

 

To set this feature:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET STANDARD 2 OF 5 MAXIMUM LABEL LENGTH below. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that represent the desired maximum label length. The selectable range for this option is 01 to 50, even numbers only. Pad all single digit numbers with a leading zero to yield a two-digit entry (01-50).

4.Complete the programming sequence by scanning the SWITCH bar code.

SET STANDARD 2 OF 5 MAXIMUM LABEL LENGTH

Product Reference Guide

6-275

Page 391
Image 391
Datalogic Scanning 9500, 9504 manual Standard 2 of 5 Maximum Label Length, To set this feature Scan the Switch bar code