Datalogic Scanning 9504, 9500 manual Maximum Host-Transmitted Message Length

Maximum Host-Transmitted Message Length

Specifies the maximum number of data characters allowed in messages transmitted to the host.

To set the Maximum Host-Transmitted Message Length:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET MAXIMUM HOST-TRANSMITTED MES- SAGE LENGTH below. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the desired maximum host-transmitted message length. The selectable range is 0-249 data characters. (Labels that are longer than this length are not read.) Pad all single and double digit numbers with leading zeroes to yield a three-digit entry (000-249).

If this configuration item is set to 0 (000), there is no general length limit imposed on data being transmitted to the host.

NOTE

4.The scanner will automatically exit Programming Mode when the appropriate amount of digits have been scanned

SET MAXIMUM HOST-TRANSMITTED MESSAGE LENGTH

6-66 Magellan® 9500