Datalogic Scanning 9500, 9504 manual Appendix E Factory Defaults

Appendix E

Factory Defaults

The following table provides a listing of the most common factory settings for the interfaces shown.

Table E-1Factory Default Settings

	Aux	RS-232	Wincor-	Single	IBM 17	IBM USB
			Nixdorf	Cable
Double Read Time-	60	60	60	60	60	60
out	(600ms)	(600ms)	(600ms)	(600ms)	(600ms)	(600ms)
Laser Timeout	20 (5 min.)	20 (5 min.)	20 (5 min.)	20 (5 min.)	20 (5 min.)	20 (5 min.)
Motor Timeout	40	40	40	40	40	40
	(10 min.)	(10 min.)	(10 min.)	(10 min.)	(10 min.)	(10 min.)
Green LED Idle State	2 (on dim)	2 (on dim)	2 (on dim)	2 (on dim)	2 (on dim)	2 (on dim)
Scanner Button	1	1	1	1	1	1
	(vol/tone/	(vol/tone/	(vol/tone/	(vol/tone/	(vol/tone/	(vol/tone/
Options
	reset)	reset)	reset)	reset)	reset)	reset)
Power-up Beep Con-	1 beep	1 beep	1 beep	1 beep	1 beep	1 beep
trol
Good Read Beep	1 (enable)	1 (enable)	1 (enable)	1 (enable)	1 (enable)	1 (enable)
Control
Good Read Beep	1	1	1	1	1	1
Frequency	(medium)	(medium)	(medium)	(medium)	(medium)	(medium)
Good Read Beep	8 (80ms)	8 (80ms)	8 (80ms)	8 (80ms)	8 (80ms)	8 (80ms)
Length
Good Read Beep	3 (med-	3 (med-	3 (med-	3 (med-	3 (med-	3 (med-
Volume	high)	high)	high)	high)	high)	high)

Product Reference Guide E-1