Global Prefix
This feature applies to
To specify the Global Prefix Character(s):
1.Scan the SWITCH bar code.
2.Scan the bar code, SET GLOBAL PREFIX below. You’ll need to cover any unused bar codes to ensure the scanner reads only the bar code you intend to scan.
3.Scan the appropriate characters/digits from the keypad in Appendix C that represent the hex designation for the desired character(s). A table containing the ASCII Character Set and their corresponding Hex Values is available in the inside back cover of this manual. ASCII parameters must be input by scanning a pair of hexadecimal digits for each character. Thus, to set a
To specify “no Global Prefix,” scan 00.
NOTE
4.If designating the full 20 hex pairs, the scanner will automatically exit Programming Mode when the appropriate amount of digits have been scanned. If designating less than 20 hex pairs, you can end the programming sequence early by scanning the TERMINATE SEQUENCE bar code.
5.Complete the programming sequence by scanning the SWITCH bar code.
Magellan® 9500 |
