A-2 Magellan® 9500
Controls and Indicators
The control panel consists of three indicator LEDs and three push buttons
as described in the following pages. The unit also includes a beeper which
can be configured to sound indications of scanning, weighing, and deacti-
vation activities.
LED and Beeper Indications
Scanner and Scale LEDs
The Scanner LED (green, top-most) indicates scanner status, and the
Scale LED (yellow, middle) is primarily used to show scale status (see
Table A-1).
NOTE
Since beeper indications are configurable, your unit may not be pro-
grammed to sound all the indications listed. For more information, see
the Programming chapter of this manual.
Table A-1. Scanner and Scale LED Indications
LED
INDICATION DURATION COMMENT
Scale at ZeroaScale (Yellow) LED on steady The scale is at rest and reads zero weight. The
scale is ready to weigh.
Scanner Activea
(Normal Mode)
Scanner (Green) LED on steady and
dim The scanner is ready for operation. Scanning is
immediately available.
Good Read
Indicationa
Scanner (Green) LED - bright flash Indicates a bar code has been read and decoded.
Program Mode
Indication
Scanner (Green) LED - Continuous
flashing Indicates the scanner is in Label Programming
Mode. Cycle power to exit Programming Mode.
Sleep Mode
Indication
Scanner (Green) LED flashes slowly The scanner motor and/or laser have automati-
cally switched off and the unit has entered Sleep
Mode due to extended inactivity.