Datalogic Scanning 9504, 9500 manual To select the desired interface, Connect new interface cables

Interface Type — continued

CAUTION

To select the desired interface:

Great care should be taken to select the correct interface type, since you can cause damage to the scanner and/or POS terminal by attempting to change to an incompatible interface. ALWAYS make interface selections with the host cable DISCONNECTED.

NOTE

NOTE

When an interface is selected, the scanner loads the factory configuration for that interface as the selection is made, erasing any and all custom config- uration that may have previously been done.

1.Disconnect current interface cable(s) if currently connected.

2.Scan the SWITCH bar code

3.Scan the bar code representing the appropriate interface located on the following pages. You’ll need to cover any unused bar codes adja- cent to and on any facing pages to ensure the scanner reads only the bar code you intend to scan.

4.Complete the programming sequence by scanning the SWITCH bar code.

Once the correct interface has been set, it will be necessary to proceed to the appropriate pages in this manual that select parameters and options for that interface. For example, if RS-232 is selected, turn to the pages in this manual headed as features specific to the RS-232 interface.

5. Connect new interface cable(s).

6-60 Magellan® 9500