Datalogic Scanning 9504, 9500 manual Maximum Label Length, 228

I 2 of 5 Maximum Label Length

	This feature specifies the maximum allowable length of an I 2 of 5 label.
	Length in this case includes check and data characters, but does not include
	start or stop characters. This feature applies when I 2 of 5 Length Control is
	set to variable-length decoding.
NOTE	Maximum label length should be greater than or equal to minimum label
	length.

To set this feature:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET I 2 OF 5 MAXIMUM LABEL LENGTH below. You’ll need to cover any unused bar codes on this and the fac- ing page to ensure that the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the desired maximum label length. The selectable range for this option is 02 to 50, even numbers only. Pad all single digit num- bers with a leading zero to yield a two-digit entry (02-50).

4.Complete the programming sequence by scanning the SWITCH bar code.

SET I 2 OF 5 MAXIMUM LABEL LENGTH

6-228 Magellan® 9500