LED and Beeper Indicators
The scanner provides a set of indicators that verify/announce the various scanner functions.
If You Make a Mistake...
If, during a programming session, you find that you are unsure of the scanner’s settings or wish to reset the scanner’s configuration, use the Return to Factory Settings label below to return the scanner’s configura- tion to the factory settings. Scanning this label will also reset any changes made during previous programming sessions.
Return to Factory Settings
CAUTION
NOTE
Scan this bar code to return the scanner to the default settings configured at the factory for the currently active interface. This bar code is typically used to return the scanner to a “known” operating state when the present programming status is not known, faulty, or suspect.
Use this bar code with caution, since it will reset ALL features that may have been programmed since the scanner’s installation.
DO NOT scan the SWITCH bar code before and after scanning this bar code, as the bar code below automatically enters and exits Programming Mode as a part of its function. If this bar code is scanned following a SWITCH bar code, it will simply cause the scanner to exit Programming Mode without making changes.
RETURN TO FACTORY SETTINGS
Magellan® 9500 |
