General Scanner and Scale Features
Double Read Timeout
The Double Read Timeout feature sets a time limit that determines how much time must pass before reading the same label again (e.g. two identi- cal items in succession).
To set the Double Read Timeout:
1.Scan the SWITCH bar code.
2.Scan your selection from the bar codes below. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.
3.Complete the programming sequence by scanning the SWITCH bar code.
If the incidence of multiple reads is not acceptable, increase the Double Read
Timeout setting to a higher value.
NOTE
DOUBLE READ TIMEOUT = 400ms
DOUBLE READ TIMEOUT = 600ms
Magellan® 9500 |
