Datalogic Scanning 9504, 9500 manual Code 128 Label ID, 212

Code 128 Label ID

This feature specifies a Code 128 label ID to be added to bar code data..

The programming feature, RS-232 Label ID Control, designates whether the

Label ID is transmitted as a prefix or suffix or if Label ID is disabled.

NOTE

To set this feature:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET CODE 128 LABEL ID below. You’ll need to cover any unused bar codes on this and the facing page to ensure the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the desired Label ID characters; entered as two hex pairs. A table containing the ASCII Character Set and their corresponding Hex Values is available in the inside back cover of this manual. ASCII parameters must be input by scanning a pair of hexadecimal digits for each character. Thus, to set a two-character value of AB, bar codes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned. The selectable range for this option is any hex value from 00 to FF.

4.Complete the programming sequence by scanning the SWITCH bar code.

SET CODE 128 LABEL ID

6-212 Magellan® 9500