Datalogic Scanning 9504, 9500 manual EAS Retry Count

EAS Retry Count

This feature sets the number of times the deactivation sequence (defined by the feature, “EAS Deactivation Duration — Retry ”) is restarted after a failed deactivation attempt.

To set the EAS Retry Count:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET EAS RETRY COUNT below. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the desired number. The selectable range is 0-15 resets. Pad all single and double digit numbers with leading zeroes to yield a two-digit entry (00-15).

A setting of zero specifies no deactivation retries upon failed deactivation attempt.

NOTE

4.Complete the programming sequence by scanning the SWITCH bar code.

SET EAS RETRY COUNT

6-52 Magellan® 9500