Datalogic Scanning 9504, 9500 manual Integrating the Scanner With Your Host System

Integrating the Scanner With Your Host System

Your scanner MUST be equipped with the correct hardware (interface board, cable, etc.) to properly communicate with your host system. Con- tact your dealer for information if you have questions about your scanner’s hardware compatibility.

You may also want to contact the dealer or your system administrator if you have no record of how your scanner was pre-programmed at the fac- tory. Scanners are typically programmed with the default settings for spe- cific interface types (see Appendix E, Factory Defaults for more information); however, your scanner may have been custom configured with settings that are unique to your company or application.

Once you know the scanner’s current settings, you can determine what changes will be required to allow communication with your host system and/or optional features you choose to modify to customize your installa- tion. After recording the modifications needed, finish reading this chapter, then turn to the appropriate page and follow the instructions to program the scanner.

When all scanner features are programmed to your satisfaction, the scan- ner is ready to be placed into operation.

Customizing Your Scanner’s Operation

Most scanner programming falls within three general categories:

•General Scanner and Scale Features — are features common to all interface types. Examples include beeper adjustments such as vol- ume and length, read verification settings, etc.

•EAS Features — control the settings for interfacing with the Sensor- matic® ScanMax ProTM EAS device.

6-2 Magellan® 9500