Datalogic Scanning 9504, 9500 manual Power-up Beep Control

Power-up Beep Control

Specifies the type of audible indication that is made when entering scan- ner-active mode on power-up. Choices are:

•No beep

•One beep

•Three beeps

To set the Power-up Beep:

1.Scan the SWITCH bar code.

2.Scan your selection from the three bar codes below. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.

3.Complete the programming sequence by scanning the SWITCH bar code.

POWER-UP BEEP = OFF

6-22 Magellan® 9500