Connecting the Unit
Connecting the Power Terminal
•We recommended that you use the special red battery and ground wire
•Recommended wires size (AWG: American Wire Gauge) is as follows. The battery wire and the ground wire must be same size.
•Use a 10 AWG to 20 AWG wire for the system remote control wire.
Battery Wire and Ground Wire Size
Wire Length | less than 3.6 m | less than 6.4 m |
Wire Size | 8 AWG | 6 AWG |
|
|
|
1.Pass the battery wire from the engine compartment to the interior of the vehicle.
•After making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery.
|
|
|
|
|
|
| Engine |
|
|
|
| Interior of | |
|
|
|
|
|
|
| compartment |
|
|
|
| the vehicle | |
|
|
| |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
| Fuse (40 A ⋅ 2) |
|
|
|
|
|
| ||||||
|
|
|
|
|
| ||||||||
Positive (+) |
| Drill a 14 | |||||||||||
terminal |
| mm hole into | |||||||||||
| Insert the |
| the vehicle | ||||||||||
| grommet into the vehi- |
| body. | ||||||||||
| cle body. |
|
|
|
|
|
| ||||||
2. Connect the wires to the terminal.
•Fix the wires securely with the terminal screws.
System remote control terminal
Power terminal | Terminal |
| |
| screw |
| GND |
Battery wire | terminal |
System remote | Ground wire |
| |
control wire |
|
WARNING
Failure to securely fasten the battery wire to the ter- minal using the terminal screws could cause the ter- minal area to overheat and could result in damage and injury including minor burns.
3.Put the wire ties in the slits and wrap the wire ties around the wires.
•Make sure the wires are connected and attached properly before wrapping the wire ties around the wires.
•Wrap the wire tie around the wire insulation, not the stripped wire.
•Cut off any excess portions of the wire ties.
Wire tie
11
