Datalogic Scanning 9504, 9500 manual Set-up, On/Off

Set-up

1.Place the scanner on the checkstand next to the counter cutout.

2.Make all connections to peripheral devices, such as the Remote Scale Display (see Figure 2-15) and EAS Controller Box (see Figure 2-20). Power on the EAS Controller Box.

Figure 2-20. EAS Controller Box Connections

	To EAS
	Antenna
	To Power
ON/OFF	To Scanner
Switch

3.Route the cables up through the cutout and connect the scanner and scale interface cable(s), EAS cable and Remote Scale Display cable (optional) to the scanner. Some POS terminals require two interface cables; one for the scanner interface and one for the scale interface. Refer to Figure 2-21for cable connection locations.

If you have a scanner with no scale, there will be only one interface cable to the POS terminal.

4.Connect the power cord to the scanner and route the other end down through the checkstand to the AC power outlet. DO NOT plug the power cord in at this time.

2-36 Magellan® 9500