Datalogic Scanning 9500, 9504 manual Code 93 Minimum Label Length

Code 93 Enable

Code 93 Minimum Label Length

This feature specifies the minimum allowable length of a Code 93 label.

Length in this case includes data characters, but does not include start, stop, full ASCII shift, or check characters. This feature applies when Code 93 Length Control is set to variable-length decoding.

NOTE Minimum label length should be less than or equal to maximum label length.

To set this feature:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET CODE 93 MINIMUM LABEL LENGTH below. You’ll need to cover any unused bar codes on this and the fac- ing page to ensure that the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that rep- resent the desired minimum label length. The selectable range for this option is 01 to 50. Pad all single digit numbers with a leading zero to yield a two-digit entry (01-50).

4.Complete the programming sequence by scanning the SWITCH bar code.

SET CODE 93 MINIMUM LABEL LENGTH

Product Reference Guide 6-253