ASSEMBLY & OPERATION
!WARNING
Remove the plug from the power source before assembly, changing accessories or cutters and making adjustments. This safety action will help prevent accidental starting of the tool which could result in serious injury.
ON / OFF SWITCH
This spin saw is equipped with a sliding ON / OFF switch
(1) located on the top of the tool (see Fig. 1).
INSTALLING CUTTING BITS – Cont’d
4. Insert new cutting bit (4) into the collet.
!WARNING
Insert the bit all the way into the collet and then pull it back between 1/16” and 1/8”. This creates an air space between the motor shaft and the bit to help prevent overheating the bit.
Before tightening the collet on the bit, make sure the flutes (spiral portion) of the bit are completely visible outside the collet. Clamping the collet on the bit flutes will result in broken bits and possible injury.
5.When bit is properly placed in the collet, depress the shaft locking button and turn the collet nut clockwise by hand as far as possible.
6.Securely tighten collet nut using the wrench.
Fig. 1
1. To turn the tool ON, slide the switch up.
2. To turn the tool OFF, slide the switch down.
INSTALLING CUTTING BITS
| ! | WARNING |
|
|
Cutting bit and router bit cutting surfaces are |
| |||
extremely sharp. Handle with caution. |
| |||
To insert a cutting bit, use the collet wrench which is in the | Fig. 2 | |||
wrench holder attached to the power cord. |
| |||
1. | Depress the shaft locking button (1) and rotate the |
| ||
|
| collet lock nut (2) clockwise with the other hand until |
| |
|
| the locking button drops into place, preventing the |
| |
|
| shaft from turning (see Fig. 2). |
| |
2. | While continuing to hold the shaft locking button IN, |
| ||
|
| use the collet wrench (3) to turn the collet nut counter |
| |
|
| clockwise. Loosen the collet nut 2 or three turns. |
| |
3. | Remove bit if one is already installed in the tool. |
| ||
9
