ACCESSORIES |
| CARTON CONTENTS |
AVAILABLE ACCESSORIES
!WARNING
Use only accessories recommended for this spin saw. Follow instructions that accompany accessories. Use of improper accessories may cause injury to the operator or damage to the spin saw.
!WARNING
Use only accessories designed for this spin saw to avoid severe injury or tool damage.
Do not use any accessory unless you have completely read the instructions or Owner’s Manual for that accessory.
LATERAL STYLE DRYWALL CUTTING BIT
This cutting bit has a fine spiral for removing high volumes of material when cutting and leaving a smooth edge.
Use this cutter for cutting drywall.
GENERAL PURPOSE CUTTING BIT
This cutting bit has a coarse spiral for removing material when being used for general cutting.
Use this general purpose cutter for cutting materials such as wood, plastic and fiberglass.
TILE BIT
This cutting bit is designed specifically for use in cutting wall tile and for removing grout from wall tile (see right).
NOTE: DO NOT use this tile bit for cutting floor tile or for removing floor tile grout. Floor tile is harder than wall tile and will cause damage to the bit.
UNPACKING AND CHECKING CARTON CONTENTS
!WARNING
If any part is missing or damaged, do not plug the spin saw into the power source until the missing or damaged part is replaced and assembly is complete.
Carefully unpack the spin saw and all its parts. Compare against the “Spin Saw Components” chart.
NOTE: See Page 7 for illustration of parts and chart.
!WARNING
To avoid fire or toxic reaction, never use gasoline, naphtha, acetone, lacquer thinner or similar highly volatile solvents to clean the spin saw.
Tile Bit
6
