REMOTE CONTROL OPERATING INSTRUCTIONS
Upon inserting a loaded CD magazine into the changer, the unit will begin automatically checking the magazine for the number of discs loaded and their locations. This will occur even if the vehicle’s ignition is turned off. This process will take approximately 45 seconds. During this time, the remote control function will be inoperative.
CONTROLS
1LCD Display
2Track/Disc Scan (SCN)
3Track/Disc Repeat (RPT)
4Track/Disc Shuffle (SFL)
5Reset Button
6Play/Pause ( 
/ II)
7Power Off Switch (OFF)
8Track (TRK) Select ( 
)
9Track (TRK) Search ( 
)
10Disc Select ( +/- )
PREPARING FOR OPERATION
1.Load CD magazine bm and insert into changer as described on page 16.
2.Turn on your car ignition and your car stereo bn and select “FM” bandbo.
3.Tune to 89.1 on the FM band bp unless you set the selection switch on the FM module to 88.7; then tune to 88.7 on the FM band.
NOTE: You may find that it will be easier to use
1 | 2 | 3 | 4 | 5 |
10 9 8 7 6
11
14
13
one of your presets specifically for CD operation.
12
FM 89.1
4.Press the Reset button bq on the remote control using a pencil tip or other thin pointed instrument.
NOTE: This is only required the First Time you use the Changer.
5.Turn on the CD changer by pressing the Play/Pause button br. The LCD panel bs will illuminate and disc number 1 will begin play.
6.Adjust your car radio’s volume, balance and tone controls for desired sound.
7.When the last track on disc 1 has played, the unit will automatically advance to the next disc in sequence and begin playing. This will continue until all discs have been played at which time the unit will begin playing disc number 1 again.
1715
INTRO SCAN REPEAT
SHUFFLE
SHFLOFF
16
13
