Audiovox ACC-56, ACC56 owner manual Procedure for Horizontal Installation

INSTALLATION

The ACC-56 changer is designed for horizontal (flat), vertical (upright) or 45-degree mounting. It must never be mounted upside- down or on either one of it's sides as explained previously.The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.

CAUTION

After setting the built-in anti-vibration springs, place the supplied Seals (B) over the holes. These seals are used to keep dust, which could cause a malfunction, out of the unit.

HORIZONTAL INSTALLATION Set the 4 anti-vibration springs to position "H".

VERTICALINSTALLATION

Set the 4 anti-vibration springs to position "V".

45° ANGLE INSTALLATION Set the 4 anti-vibration springs to position "45°".

position "H"	position "45°"
	position "V"

PROCEDURE FOR HORIZONTAL INSTALLATION

1

2

Attach bracket (L) and bracket (R) to each side of the unit, using the hexagonal bolts with washer base (M5 x 8).

A n t i - v i b r a t i o n springs position

Bracket (L)
NOTE: Use seals (A) to cover unused
mounting holes on sides of unit.	Hexagonal bolt
Bracket (R)	with washer base (M5 x 8)

Determine the mounting location, and drill four mounting holes.

Never mount the unit near the fuel tank.

Drill holes 4mm in diameter.

3

Secure the unit in place, using four self-tapping screws (M5 x 12).

Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion.

Bracket (L)

Self-tapping screw (M5 x 12)

Bracket (R)

6