Audiovox ACC-56, ACC56 owner manual Wiring the CD Changer, Orange with White Stripe Wire

WIRING THE CD CHANGER

DATA CABLE

The 15 foot data cable connects the changer to the FM module. First connect the end of the data cable labelled "TO CD CHANGER" to the 8-pin socket on the left side of the changer. Route the other end of the cable up to the car’s dashboard area near your existing car radio and plug the data cable into the 8- pin mating socket on the end of the FM modulator.

WIRING THE FM MODULATOR

The FM modulator should be positioned near your existing car stereo and the 15 foot data cable should be connected to it. Make the following connections to the FM modulator:

ORANGE WITH WHITE STRIPE WIRE

Attached to the FM modulator is a 3-foot ACC Power wire (orange with white stripe). This is to be connected to a + 12 volt circuit that is only live when the ignition is on. The best connection point is at the car’s fuse block at the “RADIO” or “ACCESSORY” identified terminals.

FM MODULATOR

15 FOOT DATA CABLE

"TO CD CHANGER" LABEL

CAR FUSE BLOCK

"RADIO" OR "ACCESSORY" TERMINAL

FM MODULATOR

ORANGE w/WHITE

STRIPE WIRE

GREEN WITH WHITE STRIPE POWER

EXISTING +12

12 VOLT

CAR BATTERY

WIRE

The 3 foot +12 Constant Power wire (green with white stripe) must be connected to a live 12 volt wire in the vehicle. You will have to check the wire you connect it to and make certain it is always live, even when the car’s ignition is turned off. If none is found, route the wire to the car’s fuse block and connect it to a live circuit there.

VOLT "LIVE" WIRE

	GREEN w/WHITE
	STRIPE WIRE
SPLICE INTO "LIVE" WIRE
AND TAPE SPLICE		5 AMP FUSE
	FM MODULATOR

FILTER BOX

15 FOOT EXTENSION LEAD (MAY NOT BE REQUIRED)

10