Models CDC-FDF & CDC-FDR
INSTALLATION GUIDE FOR:
CD CHANGER
INTERFACE CABLE for FORD VEHICLES
Form No.
CAUTION: FOLLOW THE CONNECTION SEQUENCE DESCRIBED BELOW TO ENSURE PROPER RECOGNITION OF THE CD CHANGER BY THE FACTORY RADIO.
DO NOT FORCE CONNECTORS TOGETHER. LINE UP LOCATING TABS AND CAREFULLY MATE CONNECTORS.
INSTALLATION INSTRUCTIONS FOR THE CDC-FDR: (Fig. 1)
IMPORTANT : Vehicles with electronic heating/AC controls may experience intermittent operation of these controls when the CD Changer is disconnected.
1.Mount the CD changer at the desired location in the trunk following the installation instructions supplied with the CD changer.
2.Carefully connect the
3.Route the
4.With the vehicle off, unplug the power/speaker connector from the tuner/amplifier pack.
5.Carefully connect the data cable from the
6.Carefully connect the vehicle side power/speaker cable to the mating connector on the
7.Carefully connect the power/speaker connector from the
INSTALLATION INSTRUCTIONS FOR THE CDC-FDF: (Fig. 2)
IMPORTANT : When mounting the CD Changer in the rear of the vehicle, it may be necessary to purchase separately the
1.Mount the CD Changer at the desired location either in the center console
2.Carefully connect the
3.Route the
4.Remove the factory radio from the dash panel using the factory removal tools.
5.Unplug both the power/speaker and CD Changer connectors from the rear of the radio.
6.Carefully connect the vehicle power/speaker and CD Changer connectors to the respective mating con- nectors on the
7.Carefully connect the power/speaker and CD Changer connectors of the
OPERATION CHECK:
1.Load CD's into the CD Changer cartridge and insert the cartridge into the changer.
2.Start vehicle and allow CD Changer to cycle.
Perform a brief functional test to verify proper operation according to the owner's manual.
lAudiovox Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 l | Printed in China |
