Audiovox DPF711K manual Wall Mount Installation Using the Angle Mount Brackets

HB-711-OM-128-8270-Eng.qxp 6/5/08 9:37 AM Page 10

INSTALLATION (cont’d)

Plastic Wall Anchor (2)	Drill 1/4” Hole
if Needed	(2 Places)

Angle Mount Bracket

Mounting Tabs

Wall Surface

Mounting Hole

Flat-Head Self-Tapping Angle MountTemplate

Screw (2)

Bracket (2)

Wall Mount Installation Using the Angle Mount Brackets

NOTE: It is not recommended that you use the foam adhesive pads when mounting the angle mount brack- ets to a wall surface; in this case, always use screws.

1.Position the mounting template against the wall at the desired location; level the top of the tem- plate, and mark the position of the two lower holes onto the wall.

2.Using a 1/4” (6mm) drill bit, drill two holes where you marked the wall; if a wall stud is not present, insert the provided plastic anchors into the holes until they are flush with the wall.

3.Align each angle mount bracket with its respective drilled hole and/or wall anchor; insert a flat- head screw (two provided) through each wall bracket, and secure the bracket to the wall.

4.Connect the power adapter plug to the DC input connector at the rear of the homebase.

5.Determine how best to route the power adapter wire in reference to the AC wall outlet – to the left or right side of the homebase – and slip the DC wire into the corresponding wire notch on the back of the unit.

6.Check the amount of wire required to reach the AC outlet; spool any excess wire onto the four posts inside the rear hollow of the homebase.

7.Attach each angle mount bracket to the homebase by lining up the individual angle mount bracket upper mounting tab with its corresponding hole on the homebase.

8.Cover the power adapter wire with either the clear, black or white wire cover; seal the cover using the double-sided tape provided, and then press into place, adhering it onto the wall surface.

10 DPF711K