Hold down the Monitor Button again longer than 2 seconds and the 
icon will disapppear from the display.
The monitor function will temporarily bypass the squelch setting and play all signals on a given channel. This feature is useful when communicating with other parties at extreme range.
By pressing the monitor button momentarily, the LCD backlight is turned on accompanied by a beep tone; the LCD backlight will turn off automatically in about 5 seconds, or when the monitor button is pressed momentarily once again.
Push To Talk (PTT) Button (4)
Pressing and holding this button will allow you to speak to any transceiver that is set to the same channel and privacy code setting as yours. Hold the transceiver approximately 1 to 2 inches from your face as you speak into the built in microphone (9). After you have finished speaking, release the PTT Button to allow reception of incoming signals. It is not possible to transmit and receive at the same time. The Transmit/Monitor LED (16) on the right side of the LCD Panel (8) will light red while the PTT Button is pressed.
Releasing the button allows the unit to revert to standby mode. When receiving an incoming signal, the Transmit/Monitor LED indicator will light
green and the received signal strength indicator ( 
) will display the relative strength of the signal.
The PTT Button can also be used as a
Up Channel/Volume Button (10)
In the standby mode, pressing this button will increment the listening volume. When in function edit mode this button will be used to adjust the unit’s settings. The display will indicate the current volume level between 1 and 7 by the small number in the icon ( U 05 ).
9
