Audiovox GMRS200W owner manual Operating Modes and Features, GRMS/FRS Operation, Channel Selection

Operating Modes and Features

GRMS/FRS Operation

-From GMRS/FRS standby mode, press and hold the power button for 2 seconds to turn on power.

-Press the Function (F) button so the Channel number flashes.

-Select the desired channel with the Up (10) and Down (11) Buttons. When receiving a call, the RX icon on the LCD ap- pears to indicate incoming received signal.

-Press and hold the PTT button (3) to transmit, then speak into the microphone clearly and slowly.

-Communication can only be accomplished when the channel frequency of at least two parties are the same.

-Release PTT Button (3) to receive.

Channel Selection

In order to communicate with other GMRS/FRS units, both transmitting and receiving party must be on the same frequency. The GMRS200W has 22 channels (frequencies) (1-22) indicated by the large digits on the LCD display panel. Channels 1 through 7 are the shared GMRS/FRS channels. Channels 8-14 are FRS only channels, while channels 15-22 are GMRS only channels. Communication with Audiovox GMRS/FRS and compatible units is possible on these 22 channels.

To change the channel:

- From GMRS/FRS standby mode, press the Function (F) but- ton (6) until the channel number flashes.

-Press the Up Button (10) briefly to move to the next higher main channel number.

-Press the Down Button (11) briefly to move to the next lower

main channel number.

9

128-6781

9 of 16