Operating Modes and Features

GRMS/FRS Operation:

-Press and hold the Power On/Off button for 2 seconds to turn on power.

-Press the MODE button so the Channel number flashes.

-Select the desired channel with the Up (10) and Down (11) Buttons. When receiving a call, the RX icon appears to indicate an incoming call.

-Press and hold the PTT button (3) to transmit, then speak into the microphone clearly and slowly.

-Release PTT Button (3) to receive.

-Communication can only be accomplished when the channel of at least two parties are the same.

Channel Selection

In order to communicate with other GMRS/FRS units, both the transmit- ting and receiving party must be on the same frequency.

The GMRS672 has 22 channels (frequencies) indicated by the large digits on the LCD display panel. Channels 1 through 7 are the shared GMRS/FRS channels. Channels 8-14 are FRS only channels, while chan- nels 15-22 are assigned GMRS only channels. Communication with Audiovox GMRS/FRS and compatible units is possible on these 22 chan- nels.

To change the channel:

-From GMRS/FRS standby mode, press the MODE button (9) once; the channel number flashes.

-Press the Up Button (10) briefly to move to the next higher main chan- nel number.

-Press the Down Button (11) briefly to move to the next lower main channel number.

9

Troubleshooting

Problem

Possible cause

Correction

No transmission

Weak batteries

Replace batteries

while pressing

Incorrect battery polarity

Install the batteries using

the PTT Button

 

the directions for correct

 

 

battery installation.

 

 

 

Weak or no

Weak batteries

Replace batteries

signal received

Channel

Adjust the transceiver’s

 

not set the same

settings to match those

 

as target transceiver

settings of the target

 

 

transceiver

 

Volume level too low

Increase volume level

 

PTT Button inadvertently

Release PTT Button

 

depressed

 

 

Excessive radio interference

Change to a different

 

on a particular channel

channel

 

Obstruction of radio signal

Avoid operating in or near

 

 

large buildings or vehicles

Unit beeps, but

Batteries extremely

Replace batteries

will not function

discharged

 

when turned on

 

 

Reception of

Interference from

Turn the devices off or move

unwanted

electronic devices such

farther away from them.

signals

as computers or TVs

 

 

 

 

VOX Selection Mode

This option enables you to have hands-free conversation.When using the internal microphone/speaker, your voice or the signal is detected and the radio transmits and receives automatically.Your voice or nearby sound is detected and the radio transmits without the need to press the PTT buttton.

To set the radio for VOX operation:

-From GMRS/FRS standby mode, press and hold the MODE button for 2 seconds, or until the VOX icon appears on the display.

-To terminate VOX operation, press and hold the MODE button for at least 2 seconds; the VOX indication will disappear.

Channel Scan Operation

This feature allows you to monitor all channels automatically for valid signals. While scanning, you can transmit and receive. When a signal is received, the scan is interrupted and will return to scan mode approxi- mately 5 seconds after reception is terminated.

NOTE: While the scan function is active, the MODE/VOX button will be inoperative. The scan mode will reduce the overall battery life since the battery save function is overridden.

To enable the channel scan mode:

-From GMRS/FRS standby mode, momentarily press the Power (S) Button; (SCAN) will appear on the LCD display.

-The radio will display each channel (1-22) in ascending order as the scan mode operates to find an active main channel.

-If the unit doesn’t find any signals and you want to transmit, press the PTT button to return to home channel operation. The transceiver will automatically resume scanning approximately 5 seconds after the communication is completed.

-If there is no activity and you want to leave the scan mode, press the S button momentarily and the unit will return to normal operation;

the SCAN icon will disappear from the LCD display.

10

Technical Specifications:

General

Frequency Range:

 

Channels 1 through 7 are

 

shared with FRS radios.

Refer to frequency chart on next page.

Channels 8 through 14 are

 

FRS only.

Refer to frequency chart on next page.

Channels 15 through 22 are

 

GMRS only.

Refer to frequency chart on next page.

Channel Spacing

12.5kHz

Dimensions (W x H x D)

1.96” W x 3.31” H x 1.10” D

(Without Antenna)

(49.8 mm x 84.0 mm x 28.0 mm)

Power Supply

 

Power Source

Alkaline Batteries, AAA (3), 4.5 VDC

Operating Time

30 hours

(Transmit: Receive: Standby)

 

(5: 5: 90 ratio)

 

(Based on alkaline batteries)

 

Receiver

 

Useable Sensitivity

>-119 dBm

Maximum Audio Output Power

> 0.25 Watt maximum (8 Ohm )

Modulation Distortion

< 5% (1 kHz 70%)

Transmitter

 

RF Output Power

0.5 Watt maximum

Maximum Deviation

+/- 2.5 kHz

Modulation Distortion

< 5% (1 kHz 70%)

Button Beep (Key Tone)

This feature allows the transceiver to sound a confirmation tone whenever the following keys are pressed: Power On/Off/SCAN Button, Up/Down But- tons and MODE Button. This feature is always on.

Roger Beep Tone

The Roger Beep is a tone which is automatically transmitted whenever the PTT button is released and the tone is enabled. This tone alerts the re- ceiving party that the transmission has been terminated intentionally

To enable and disable the Roger Beep tone:

-From GMRS/FRS standby mode, press the MODE Button 2 times

until the flashing Roger Beep icon ( ) appears with on or oF.

-Press the Up or Down Button to select the tone on or off as desired.

-When enabled, the tone icon ( ) appears steady on the display.

-Press the PTT button momentarily to confirm selection.

Battery Alert

When the battery icon (

) blinks on/off at 7-second intervals, as shown

on the LCD panel, recharge or install fresh batteries.

NOTES FOR GOOD COMMUNICATION

1 . The 22 channels of the GMRS672 are shared on a ‘take turns’ basis. This means other groups may be talking on any of the chan- nels. A common code of ethics/courtesy is to switch to another vacant channel and not to attempt to talk over someone who is already using the channel you first selected.

2.The GMRS672 has been designed to maximize performance and improve transmission range in the field. To avoid interference, it is recommended that you do not use the units closer than 5 feet apart.

3.For best transmission results, always keep your mouth about 2-3 inches from the microphone (5) and speak slowly in a normal voice.

4.To increase battery life, use the SCAN feature sparingly. This feature will reduce operating time considerably.

11

This transceiver complies with FCC regulations for use in the United States of America. Use in other countries may be prohibited or restricted by local regulation. Please check with the local regulating agency be- fore using this device outside the United States of America.

Main Channel Frequencies:

CHANNEL/TYPE

FREQ (MHz)

CHANNEL/TYPE

FREQ (MHz)

 

 

 

 

 

 

1

GMRS/FRS

462.5625

12

FRS

467.6625

 

 

 

 

 

 

2

GMRS/FRS

462.5875

13

FRS

467.6875

 

 

 

 

 

 

3

GMRS/FRS

462.6125

14

FRS

467.7125

 

 

 

 

 

 

4

GMRS/FRS

462.6375

15

GMRS

462.5500

 

 

 

 

 

 

5

GMRS/FRS

462.6625

16

GMRS

462.5750

 

 

 

 

 

 

6

GMRS/FRS

462.6875

17

GMRS

462.6000

 

 

 

 

 

 

7

GMRS/FRS

462.7125

18

GMRS

462.6250

 

 

 

 

 

 

8

FRS

467.5625

19

GMRS

462.6500

 

 

 

 

 

 

9

FRS

467.5875

20

GMRS

462.6750

 

 

 

 

 

 

10

FRS

467.6125

21

GMRS

462.7000

 

 

 

 

 

 

11

FRS

467.6375

22

GMRS

462.7250

 

 

 

 

 

 

NOTE: Channels 1 through 7 are shared with FRS radios. Channels 8 through 14 are FRS only.

Channels 15 through 22 are GMRS only.

Warning

Do not operate the transceiver unless you are licensed to do so.

Remove the batteries from the transceiver if it is not expected to be used for long periods. This will eliminate the possibility of chemicals leaking from the batteries and corroding the transceiver.

Avoid exposing the transceiver to water or extremes of temperature.

Do not use this device in or near a mining facility, which uses remotely triggered explosives or in areas labeled “Blasting Area”. Premature or accidental detonation may result.

Do not attempt to modify or in any way increase the output of this transceiver. Its output is designed to meet the legal limits set by the FCC.

Do not use this device or change its batteries in potentially explosive atmospheres as sparks in such areas could result in an explosion.

Turn your transceiver off wherever posted notices restrict the use of radios or cellular telephones. Facilities such as hospitals may use equip- ment that is sensitive to RF energy.

Turn your transceiver off on board aircraft when requested to do so.

Do not place your radio in front of a vehicle’s air-bag. If the air-bag deploys, it could propel the transceiver like a projectile causing bodily injury.

12

90 DAY LIMITED WARRANTY

Applies to Audiovox Family Radio and General Mobile Service Products.

AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.

To obtain repair or replacement within the terms of this Warranty, the product is to be delivered with proof of warranty coverage (e.g. dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below.

The Company disclaims liability for communications range of this product.

This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishan- dling, misuse, neglect, accident, or by removal or defacement of the factory serial number/ bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT.

This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED

WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MER- CHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 12 MONTHS FROM DATE OF ORIGINAL PURCHASE. IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. No person or representative is authorized to assume for the Company any liability other than expressed herein in connection with the sale of this product.

Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights and you may also have other rights which vary from state to state.

AUDIOVOX CORPORATION, 150 MARCUS BLVD., HAUPPAUGE, NEW YORK 11788

1-800-290-6650

128-5385C

13

14

15

Page 2
Image 2
Audiovox GMRS672 GRMS/FRS Operation, Channel Selection, VOX Selection Mode, Channel Scan Operation, General, Power Supply