Audiovox IM-500 owner manual Setting The Clock, bt RE-SETBUTTON

bt RE-SET BUTTON

A re-set button is located on the front panel which must be activated by a pen tip or other thin object as it is recessed to prevent accidental engagement. The re-set circuitry is provided to protect the microprocessor circuitry and should only be activated under the following circumstances as it will erase the time and station pre- set memories.

1.Upon initial installation after all wiring is completed.

2.If there is a malfunction of any of the switches on the unit, pressing the re-set button may clear the system and return to normal operation.

SETTING THE CLOCK

1.Switch the vehicle ignition “on” and the radio “on .

2.If the radio frequency is shown on the LCD panel bl , press the Time/Frequency Selector (T/F) bs momentarily so that the time display is shown.

3.With the time display on the LCD panel, press and hold the Time/Frequency Selector (T/F) bs, for approximately 2 seconds until the time display begins flashing.

4. Within 5 seconds of the display beginning to flash, press the Down Tuning ( ) button 7to adjust the hours, then the Up Tuning () button 6adjust the minutes to the correct time.

5.After setting the correct time, press the Time/Frequency Selector (T/F) again or wait 5 seconds for the display to stop flashing.