Mounting monitor

ANever install the monitor in an area where the head could impact in case of an accident!

AObserve safety standards concerning the driver’s field of vision and airbag inflation area!

The monitor can be fastened with a support which is available on the market for accessories.

Depending on the type of monitor (4:3 or 16:9 display) you use you can select the rectification for guidance pictograms. The system is adjusted to a 16:9 diplay by factory default.

Installing holder for the remote control (optional), ill. 8 - 9

Mounting on angle bracket

Screw holder to angle bracket. Either insert angle bracket into an available slot or screw it in place.

Mounting with adhesive plate

Snap holder onto plastic plate. Remove protective paper from adhesive tape. Stick holder with adhesive plate onto mounting surface and press firmly.

Note: Mounting temperature should be at least 60 degrees Fahrenheit to ensure the full adhesive effect of the tape.

Completing electrical connections, ill. 10

Lay all cables carefully. Refer to the connecting diagram on page 3 and to the table below.

Power supply cable (ISO connector A):

Pin no.

Cable color

Connection

 

A1

black/white

Speedometer signal input, digital (long cable)

A2

white/yellow

Back-up lights (reversing signal)

 

 

 

 

A3

black/white

Speedometer signal input, analogue (short cable)

 

 

 

 

A4

red

+12V permanent power supply - fuse 10 A if necessary

 

 

 

 

A5

white/blue

Switch input “Accessory”

 

 

 

 

A6

grey

Switch input low beam (do not connect to dashboard illumination!)

 

 

 

 

A7

violet

+12V switched - must not be interrupted during engine start

 

 

 

 

A8

brown

Negative battery pole

 

 

 

 

= connection required = connection optional

AOnly connect electrical signals to appropriate terminals in the vehicle.

AIn the case of a direct connection to the battery secure the positive connection (red lead) with a 10 A fuse close to the battery (approx. 10 - 15 cm).

1.Connect the free cable ends A4, A7 and A8 of the power supply cable to suitable terminals in the vehicle according to the connecting diagram and the table.

2.Do not cut off unused cables! Wind them together and tie them back! They may be used later to install additional features.

English

4

Page 7
Image 7
Audiovox NPD 5400 manual Mounting monitor, Installing holder for the remote control optional, ill