TYPICAL CHRYSLER APPLICATION (See Figure 2.)
Radio Preparation:
NOTE: For Chrysler car installations, use the Chrysler Hardware Kit, Part Number
1.Select two of the four mounting tabs provided and match the radio mounting style of the vehicle as shown in Figures 3, 4 and 5. NOTE: The tab number is stamped on the bottom of the tab.
2.Attach the mounting tabs to the radio chassis with the four small
3.Attach the
4.Plug the antenna cable into the antenna socket on the radio.
Installation:
1.Attach the ring lug on the ground wire (black) from the radio side harness along with the vehicle side grounding strap to the rear of the radio chassis using the short quickie bolt (Item #2) and the flange nut (Item # 4) provided.
2.Connect the mating side of the harness to the vehicle side wiring harness.
3.Connect the vehicle antenna cable to the radio antenna connector.
4.If a compatible CD changer is to be used with this radio, connect the cable from the changer to the
5.Reconnect the battery, and perform a brief functional test of the radio to verify proper performance.
6.After verification, turn off the ignition switch and install the radio into the
7.