Audiovox PSW-12DC, PSW-10DC manual SERIES/PARALLEL Stereo Connection

two dual-voice coil 4-Ohm woofers are connected in parallel and then wired to each other in parallel, a 1-Ohm monaural output would result (See Fig. 2). On the other hand, if your amplifier is rated for 4-Ohm operation in bridged or one-channel operation, series-connect the woofer voice coils (See Fig. 3). If the amplifier is rated for 8 Ohms, interconnect the voice coils of the woofer in series as shown to obtain 8-Ohm monaural output (See Fig. 4).

PARALLEL

2 Ω + -

2 Ω MONO

- +

Fig. 1

2 Ω +	-	+	- 2 Ω
	2		1 Ω
			MONO
-		-
	+		+

Fig. 2

SERIES

8 Ω +	-		- 8 Ω
		+
			4 Ω
-			MONO
	+	-	+

Fig. 3

8 Ω + -

8 Ω MONO

- +

Fig. 4

SERIES/PARALLEL STEREO CONNECTION

Series wiring of each of two, dual voice-coil 4-Ohm woofers will result in a total impedance load of 8 Ohms at each channel of the amplifier (See Fig. 5). Otherwise, connect one woofer to each channel for 4-Ohm stereo operation (See Fig. 6), or two parallel-wired woofers (one-per-channel) for 2-Ohm stereo operation (See Fig.7).

+	-			+	-
8 Ω		L
					4 Ω
-	+	8 Ω			STEREO
				4 Ω-	+
+	-	STEREO
8 Ω					Fig. 6
		R	-2 Ω
-	+	+
				L
	Fig. 5
		-
			+	2 Ω
		+	- 2 Ω	STEREO

R

- +

Fig. 7

3