SIR6
Adjustments
There are three areas of adjustments on the antenna, antenna arm and mounting bracket. Please use these areas to adjust the antenna so that it is level. You will have to loosen the Phillips screws to rotate and adjust. Once the adjustment has been made to the desired position, tighten the Phillips screw. Be careful not to over tighten. We recommend that you make the adjustments, if needed, to each area in the order that is shown below.
3
2
1
Cable Installation
At this point you are ready to attach the cable.
The connectors at each end of the cable are different. find the connector that has the threads on the inside, then screw this connector onto the bottom of the antenna as shown below. Screw the connector on by hand as far as it can go. It is not necessary
to use any special tools for this.
Once the cable is secured onto the antenna, slide the attached rubber bottom onto the antenna as shown. Uncoil the remaining cable. On one side of the mounting bracket arm is a cable track with five cable clips.
For improved cable routing, snap the cable into the cable clips as shown below.
SIR6
Cable Installation
At this point, please determine the best way to route the rest of the cable into your home to the SIRIUS home receiver or SIRIUS Plug & Play system. If the included cable is not long enough to reach your receiver,
you will have to purchase a TERK 50’ extension kit
Specifications
Electrical Specifications |
|
Antenna |
|
Frequency: | 2320 to 2332.5 MHz |
Gain: | 1 dBic, |
Bandwidth: | 12.5 MHz |
Impedance: | 50 ohms |
Polarization: | LHCP (Circular) |
LNA |
|
Gain: | 42 dB, typical |
Noise Figure : | 0.7 dB, typical |
Current Drain: | 160 mA, maximum |
Mechanical Specifications |
|
Antenna Dimensions: |
|
Radome: | 3 1/4” x 3 1/4" |
Arm Length: | 8” |
Mounting bracket: | 4 3/4" x 2 7/8” |
Material: | Xenoy and AES |
Cable Type: | |
Cable Length: | 30 feet |
Connectors Antenna: | SMA |
Connectors Cable: | SMA and SMB |
Mounting Hardware |
|
Nuts and Washers: | Stainless Steel |
Screws and | Stainless Steel |
Weight including cable: | 1.75 lbs |
Other Specifications |
|
Temperature: | |
Quality and Performance Tests |
|
SIRIUS Approved: | Per Specification |
| |
TERK Approved: | Per Environmental |
| Specification TERK TRK- |
|
6 7