BEFORE INSTALLING THE UNIT
Transport Lock Screws
TRANSIT BOLTS
(2 RIGHT SIDE, 1 LEFT SIDE)
The mechanism in the CD changer is "locked" into place during shipment by the transport screws. Be sure to remove the screws prior to installation.
l Caution l
After removing the transport lock screws, place a piece of masking tape over each screw hole. The tape will keep out dust , which could cause the unit to malfunction.
Installation and Wiring Precautions
1 To prevent a
lBe sure to turn off the ignition and remove the negative
lConnect power wires last.
Note
If the changer is to be installed in a car that is equipped with an
2 | Do not install the unit in the following locations. |
| l Locations exposed to direct sunlight. |
| l Where hot air is discharged from the car heater. |
| l In areas subject to extreme temperatures. |
3 | Incorrect installation can cause the sound to "skip" when playing a disc. |
| Mount the unit firmly in place, using the supplied brackets and screws. |
4 | Be careful not to damage the car wiring. |
5 l Be sure to use the supplied screws.
lBe careful not to snag any wires when tightening screws.
lDo not use any of the screws that are part of the brake or steering system, to install the unit.
6 | l This unit cannot be installed on either side or |
to malfunction. |
3