Procedure For Vertical Installation W/O Studs

PROCEDURE FOR VERTICAL INSTALLATION W/O STUDS

Note

If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 4), start with step 2.

1	Set the 2 anti-vibration springs to position "90".

2	Attach bracket to each side of the unit, using machine
	screws with integral flat and lock washers. (M4 x 10).
	In the vertical position, use holes 2 and 2' as shown
	at left.

NOTE: Use masking tape to cover unused mounting holes on sides of unit.

BRACKET (Left Side)

MACHINE SCREWS w/WASHERS (M4x10)

BRACKET

(Right Side)

Determine the mounting location, and drill four mounting holes.

Never mount the unit near the fuel tank.

4 Mount the unit in place, using four self-tapping screws (M5 x 12).

Use RTV (silicone sealer) on screw threads and around the holes to prevent moisture intrusion.

SELF-TAPPING

BRACKETSCREWS (M5 x 12) (Left Side)

BRACKET (Right Side)