Audiovox SP-11CD installation manual Stud Bracket Mounting

PROCEDURE FOR CHANGER INSTALLATION USING MOUNTING STUDS

Note:

Make sure the anti-vibration spring position has been changed and verified for the proper angle mounting (as shown on page 4).

1Determine mounting location. If unit is to be installed onto mounting studs located under carpet, lift carpet to expose metal chassis and mark position of each stud as shown below in detail A and B.

2Insert two hexagonal mounting bolts through underside of each bracket (detail A) and mount stud bracket in position using two self-tapping screws into metal chassis. Hex bolt heads should be flush with underside of stud bracket.

3Replace carpet over bracket studs (detail B), mark position of stud end of each bolt, and cut holes in carpet so bolts protrude through carpet.

4Proceed with unit mounting by positioning unit mounting brackets over protruding hex bolts as shown in details C, D and E. Secure mounting brackets to bolts using hex lock nuts.

5If mounting studs are to be located directly on mounting surface with no carpet in between, mount changer directly on studs as illustrated below in details A, C, D and E.

STUD BRACKET MOUNTING	STUD BRACKET MOUNTING
ARRANGEMENT
		UNDER A CARPET
(Detail A)
		(Detail B)
SELF-TAPPING SCREWS
(M5 x 12)
		CARPET
STUD BRACKET		STUD BRACKET
HEX BOLT (M6 x 15)
		CHASSIS
VERTICAL INSTALLATION	SUSPENDED INSTALLATION	HORIZONTAL INSTALLATION
WITH STUD BRACKET	WITH STUD BRACKET
		WITH STUD BRACKET
(Detail C)	(Detail D)
		(Detail E)
		HEX NUT (M6)
HEX NUT (M6)	STUD BRACKET

STUD BRACKET	CHANGER MOUNTING
	BRACKET
CHANGER MOUNTING	STUD BRACKET
	HEX NUT (M6)
BRACKET	CHANGER MOUNTING
	BRACKET

7