Audiovox TFT3500 user manual Ac Adapter/Charger

Watching TV

Extend the antenna.

Set the power switch to VHF (channels 2-13) or UHF (channels 14-69). The TV starts scanning and stops at the first active signal. Press the tuning +/- buttons to change channels. The channel indicator(red for VHF and green for UHF) aligns with the selected channel number on bottom of the screen.

Adjust the volume to a desired level.

Adjust the brightness if the image is too light or dark

Note: If reception is poor,adjust the length or angle of the antenna. If inside a metal or concrete building, moving closer to a window may improve the reception.

Audio/Video in

With a compatible audio/video adapter(not included), your TV can receive signals from a video device, such as a camcorder or VCR.

Conncet the RCA plugs into the video and left/mono jacks of the video device. The yellow plug is for video, the white plug is for audio.

Plug the 3.5mm plug into the A/V IN jack on the side of the TV. Turn on theTV.

Note:Plugging in this jack switches the TV from TV mode to Video mode. Uplugging this jack will return the TV to TV mode.

Powering UP continued

AA NIHM BATTERIES:

Press the battery cover release tab and gently lift the battery cover open.

Set the recharge switch located inside the battery compartment to the "ON" position

Insert the four NiMH batteries observing the polarity symbols(+and -) shown inside the battery compartment. Close battery cover.

Connect the AC adaptor/charger to the DC input connector. Charge the batteries for at least 2 hours. The charge indicator will be illuminated while the batteries are recharging.

If using the AC adaptor with Alkaline batteries installed in the TV, you MUST switch the Recharge switch to "OFF" position.Failure to do so can result in personal injury or damage.

AC ADAPTER/CHARGER:

A 6V DC 500mA AC adaptor/Charger can also

be used to power the TV in your home or office. Simply connect the AC adaptor/Charger to the DC Input on your TV. The rechareable NIHM batteries will be recharged while you are watching the TV, though the recharge time will be increased. For best results, it is recommended that you recharge the batteries with the unit off.

Headphones

For private listening,you can connect optional mono headphones to the 3.5mm EAR jack. This automatically mutes the built-in speaker.

Set the VOLUME to the lowest setting before you plug in the headphones. After the headphones are connected, adjust the volume to a comfortable level.

TV Stand

The TV stand (located on the rear of this unit) gives you the convenience of placing the TV on a flat surface for easy viewing. Pull the stand slowly until it locks into place. Do not pull the stand beyond the lock position. When finished using the stand, snap it back into place.

Troubleshooting
Problem	Solution
No picture and/or	Check the battery polarity.
no sound	If using an AC power adaptor, make
	sure it is the correct voltage(6VDC 500mA), the
	correct polarity +/-, and connected
	properly.
	Recharge the batteries.
	Change the batteries.
Picture,but no sound	Make sure headphones are
	disconnected.
	Adjust VOLUME control.
	If using an external video source, check
	all connections.
Sound, but no picture	Check the Batteries. Batteries may
	need replacement or charging
	Adjust the antenna.
	Adjust the brightness.
	If using a video source, check all
	connections.
No color	Adjust the antenna.
	Re-adjust the tuning.
Picture not clear	Extend the antenna fully and adjust the
	angle and direction.
	Re-adjust the tuning.
	Batteries may need charging or
	replacement if alkaline.
	Move the TV away from devices which
	may cause interference.