UV7i

PREPARATION

Congratulations on your purchase of the Phase Linear UV7i Mobile Multimedia Receiver.

It’s a good idea to read all of the instructions before beginning the installation. We recommend having your Phase Linear UV7i installed by a reputable installation shop.

Features

DVD

Compatible formats: DVD-R, DVD-RW, DVD+R, DVD+RW, CD-R, CD-RW, CD-DA, MP3, WMA, SVCD, VCD, AVI and MPEG1, MPEG2 and JPEG

Region 1 playback

16:9 Aspect ratio - Normal / Cinema/OFF

Front panel DVD control

High-speed Fast Forward / Fast Rewind 2X, 4X, 8X, 32X

Play, Pause, Stop, Slow

Chapter Up / Down

Wolfson Microelectronics high performance 24-bit, 192 kHz DAC supports 2-channel "Down-Mix” audio modes

MP3/WMA

GIGA MP3 - Store up to 999 MP3 files on a DVD

ID3-tag compatible

Direct track access

Play, Pause, Stop, Track Up / Down

CD

CD-text compatible

High-speed audible track search

Random, repeat A-B, intro

Play, pause, slow, track up/down

Last position memory

AM/FM Tuner

US/Euro/Latin/Asia Tuner

30 Station presets (18FM/12AM)

Made for iPod

Controls and charges all iPod's except "Shuffle"

Displays all text information including category, track name, artist and channel number

Chassis

7-inch TFT active-matrix LCD, 336, 960 pixels (1440W X 234H)

Full automatic motorized TFT LCD flip-out and up

16-step TFT LCD tilt adjustment

1.0 Din (Single DIN)

Import ISO/DIN mountable

Trim Ring Included

Beep Tone confirmation

Heat management system - Incorporates forced air- cooling to keep the chip-sets operating at nominal temperatures

Heavy duty galvanized chassis

General

Full function infrared remote control

1 NTSC composite video output for additional screens

OSD - On Screen Display menu control

High performance audio processor

Electronic volume, bass, treble, balance and fader

Bass center frequency adjustment - 60, 80, 100, 130, 150 and 200Hz

Bass Q factor - 1.0, 1.25, 1.5 and 2.0

Treble center frequency adjustment - 10, 12.5, 15 and 17kHz

Subwoofer crossover - 80, 120 and 160Hz

Subwoofer Phase - 0, 180 degrees

Subwoofer level - variable

100-ohm low impedance preamp outputs - all channels

5V Peak / 2V RMS RCA outputs - all channels

1-pair Front RCA outputs

1-pair Rear RCA outputs

Single Subwoofer RCA output

1-pair Auxiliary RCA A/V inputs

Flex fader

Front panel (when screen is closed) high contrast LCD

Rotary encoder audio control

Joystick menu navigation

Tools and Supplies

You will need these tools and supplies to install your UV7i:

Torx type, flat-head and Philips screwdrivers

Wire cutters and strippers

Tools to remove existing radio (screwdriver, socket wrench set or other tools)

Electrical tape

Crimping tool

Volt meter/test light

Crimp connections

18 gauge wire for power connections

16 – 18 gauge speaker wire

WARNING! Only connect the unit to a12-volt power supply with proper grounding.

WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions.

WARNING! Never disassemble or adjust the unit.

WARNING! To prevent injury from shock or fire, never expose this unit to moisture or water.

WARNING! Never use irregular discs.

WARNING! To prevent damage to the mechanism inside this unit, avoid impact to the TFT monitor.

WARNING! Using an improper fuse may cause damage to the unit and result in a fire.

WARNING! To prevent damage to the screen, avoid touching it with your fingers or other objects.

WARNING! The monitor employs an automatic motorized mechanism. To prevent damage to the core mechanism, please do not push, pull or swivel the monitor manually.

1

Page 5
Image 5
Audiovox UV7I instruction manual Preparation, Features, Tools and Supplies