Audiovox XMB10 manual 128-7546 6 of, VOLUME +/- Pushbuttons Increase or decrease

is also located on the front panel. When the Xpress® Receiver is installed in the boom box, the

1.PHONES Jack: Accepts a stereo headphone jack to provide private listening capability for the Boom Box.

2.AUX Jack: Accepts an audio input signal from an external audio device. When using the AUX audio input, turn the Receiver off to preserve battery power. Adjust the volume level of the external audio device to obtain an audio output from the XMB10. The volume control on theexternal audio device should be set to mid-range.

3.VOLUME +/- Pushbuttons: Increase or decrease

the volume of the audio output signal from the

XMB10. To increase the 6 volume level, press

the + pushbutton; to decrease the volume level, press the

- pushbutton.

1 2 3 4 5

NOTE: The Volume buttons on the Remote Control unit (included w/Receiver Combo) will also control the volume output of the Boom Box.

4.Power On/Status/Low Battery LED: The LED lights blue when the Power On/Off pushbutton is pressed to apply power to the XMB10. When operating on AC current, the LED will briefly flash approximately every 10 seconds. When operating on DC(batteries) current, the LED will briefly flash approximately every 5 seconds.

The LED will also indicate the status of the volume pushbuttons when the AUX Jack is in use; the LED will flash each time the Volume + or - button is pressed until the maximum setting is reached in either direction. Then the LED will resume power source flashing as before.

5.Power On/Off Switch: When pressed, applies power to the Boom Box; the power on LED indicator (4) lights blue.

6.EJECT Button: Press this button to release the spring-loaded XMB10 mounting plate to install and remove the Xpress® Receiver from the Boom Box.

-6-

128-7546

6 of 16