![](/images/new-backgrounds/1249334/2493349x1.webp)
INSTALLATION
LOGO ROTATION
IN-OUT PANEL
FUNCTIONS
2 - Remove the plate without damaging the silkscreen printed panel which will have to stay on. We suggest that you seize both plate grips with your hands and pull them by blocking the silkscreen printed panel with your fingers against the amplifier chassis at the same time. This will permit to remove the plate from the panel without damages.
1 - Remove the transparent cover which protects controls and then the 4 screws which block the metal plate by using multispanner.
P O W E R
IN OUT
REMOTE
FUSE
3 - Remove the strip with audison logo.
1
CH A/HI-PASS, CH B/LO-PASS
Power outputs of the amplifier left and right channels. Connect the speakers cables to these outputs according to polarity. Terminal blocks accept cables up to 9 A.W.G. max (see “audison cable products for electronic connections” as far as their size is concerned). We recommend the use of audison cable products.
Please use +L and
2
2
PPS (Phantom Power Supply)
Power supply socket for audison external audio accessories.
3
1
1
4 - Put the strip back again after turning it, so that audison logo is upside down.
3
4
5 - Mount the plate back by fixing it through the screws; then,
IN A
Left (L) and right (R) inputs of the amplifier A channels. The preamplified outputs (PRE OUT) of a source (head unit, CD player, DAT, etc.) or of an external electronic crossover must be connected to them.
Connect only the right (R) channel input in order to use the amplifier in mono.
4
IN B/OUT
Left (L) and right (R) inputs of the amplifier B channels or amplifier HI/BYPASS preamplified outputs (see “Configurations table”). Connect only the right (R) channel input in order to use the amplifier in mono.
20 | 5 |