Aussie 6804T8UK91 manual Manually Lighting the Side Burner

23

Manually Lighting the Side Burner

!WARNING

To reduce the risk of serious bodily injury or death from fire, explosion or burn hazard:

•Open Side Burner Lid before lighting the grill to prevent an explosion from gas build-up.

•When manually lighting Side Burner, use Matchlight Holder.

1.Open the Side Burner Lid.

2.IMPORTANT: Make sure Side Burner Control Knob is turned “Off” first.

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8, page 19)

4.Push Side Burner Control Knob in and turn counterclockwise to the High position.

5.Hold lit Match, using Match Holder, near Burner.

6.If the Burner fails to light, repeat Steps 3-5.

If the burner fails to light after three or four attempts following Steps 3-6, turn the Side Burner Control Knob to the “Off” position and close the LP Gas Cylinder valve to dissipate an accumulated gas. Wait five minutes; then repeat the lighting procedure.

NOTE: If the Burners still fail to light, refer to Troubleshooting Section.

Hold lit match near Burner

Fig. 14 Side Burner Control Knob