Autostart AS-3472TW-FM Remote Starter Features

User Guide P. 9

c. START/STOP to shut down the engine without affecting the doors.

Note: The vehicle will also enter Ready Mode once the engine run time expires.

Press the button for approximately 1 second. The parking lights will come ON to inform you that

the remote starter has received your signal. Approximately 5 seconds later, the engine will start.

The parking lights will remain ON during the pre-programmed run time of the engine.

If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and

try to start the engine again. If your vehicle is equipped with an automatic transmission, there will

be 3 start attempts before the system gives up.

With the vehicle running under remote control, press the UNLOCK button to disarm the Starter Kill

and/or the OEM-style alarm (if installed) and unlock the doors. Enter the vehicle and do the

following:

1. Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK

position while the engine is running. This would cause the starter motor to re-engage.)

2. Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Remote Starter Features

Convenience feature: Idle Mode allows the user to keep the engine running and the doors

locked while they stop, for example, at a convenience store or for a short delivery.

This feature allows the user to let the remote starter take over control of the vehicle (i.e. no Key in

the Ignition Switch) while the engine is running.

If the vehicle has an automatic transmission, proceed as follows to set the system to Idle

Mode:

1. With the engine running, make sure to release the brake pedal and press the LOCK, UNLOCK or

START/STOP button on the transmitter until the parking lights come ON.

2. Remove the ignition key from the ignition switch.

The engine will continue running.

3. Exit the vehicle and close all doors, hood and trunk.

4. Press the LOCK button to leave the doors locked.

This will also arm the OEM-style alarm and starter kill (if configured).

5. Press the UNLOCK button to leave the doors unlocked.

Note: The engine will continue running until the user re-enters the vehicle or until the expiration of

the engine run time.

If the vehicle has a manual transmission, Idle Mode can be activated through the same routine

as that used for Ready Mode (see “Ready Mode Option” in this Guide); at the last step, the

TRUNK button is pressed instead of the other buttons.

Please note that the horn will honk once and that the OEM-style alarm will be armed if the

Idle Mode option is enabled.

Note: If the pre-programmed run-time expires or if the user shuts down the engine by remote

control, the vehicle will enter Ready Mode.

Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.